Table of Contents
Advertisement
Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
Steps
1. Go to Configuration → Network → Basic Settings → PPPoE .
2. Check Enable PPPoE.
3. Set the PPPoE parameters.
Dynamic IP
After successful dial-up, the dynamic IP address of the WAN is displayed.
User Name
User name for dial-up network access.
Password
Password for dial-up network access.
Confirm
Input your dial-up password again.
4. Click Save.
5. Access the device.
By Browsers
By Client Software
Note
The obtained IP address is dynamically assigned via PPPoE, so the IP address always changes
after rebooting the camera. To solve the inconvenience of the dynamic IP, you need to get a
domain name from the DDNS provider (e.g. DynDns.com). Refer to Access to Device via Domain
Name for detail information.
12.8 Accessing via Mobile Client
Hik-Connect is an application for mobile devices. Using the App, you can view live image, receive
alarm notification and so on.
Note
Hik-Connect service should be supported by the camera.
12.8.1 Enable Hik-Connect Service on Camera
Hik-Connect service should be enabled on your camera before using the service.
You can enable the service through SADP software or Web browser.
Enter the WAN dynamic IP address in the browser address bar to
access the device.
Add the WAN dynamic IP address to the client software. Refer to the
client manual for details.
76
Advertisement
Table of Contents
