Table of Contents
Advertisement
Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
8.2 Set Preset
A preset is a predefined image position. For the defined preset, you can call the preset No. to view
the position.
Steps
1. Click to show the setting panel, and click
2. Use the PTZ control buttons to move the lens to the desired position.
3. Select a preset number from the preset list, and click
Note
Some presets are predefined with special command. You can only call them but not configure
them.
4. Repeat the steps above to set multiple presets.
Click the button to call the preset.
Click the button to delete the preset.
Note
You can delete all presets in Configuration → PTZ → Clear Config . Click Clear All Presets, and
click Save.
What to do next
Go to Configuration → PTZ → Basic Settings to set preset freezing and preset speed.
After enabling preset freezing, the live image switches directly from one preset to another, without
showing the areas between these two scenes. It also guarantees the masked area will not be seen
when the device is moving.
8.2.1 Special Presets
You can call the following presets with special demands to enable corresponding functions.
Preset No.
34
35
36
37
38
39
Function
Back to origin
Call patrol 1
Call patrol 2
Call patrol 3
Call patrol 4
Day mode
.
to finish the setting.
Preset No.
92
93
94
95
96
97
36
Function
Set manual limits
Save manual limits
Remote reboot
Call OSD menu
Stop a scan
Start random scan
Advertisement
Table of Contents
