Set Vca Parameters; Configure The Behavior Analysis - HIKVISION DS-2TD4137-25/W User Manual

Thermal & Optical Bi-spectrum PTZ Network Camera User Manual

5.2 Set VCA Parameters

Steps
1. Go to Configuration → Local .
Rules
Enable it to display rules information on live view.
Display Rules Info. on Capture
Select Yes to display rules information on the capture.
2. Go to Configuration → VCA → Basic Settings .
Display VCA Info. on Stream
Select to display target info and rule on stream, the information will be added to the video
stream, and the overlay will be displayed if you get live view or play back by the VS Player.
Target Marking Color
The frame color of human is shown as orange, the frame color of vehicle is shown as purple.
Display Target Info. on Alarm Picture
Select to display the target information on the alarm picture.
Display Rule Info. on Alarm Picture
Select to display the rule information on the alarm picture.
Snapshot Settings
Select to upload the picture to the surveillance center when the VCA alarm occurs. You can
also set the quality of the picture.
3. Click Save.

5.3 Configure the Behavior Analysis

This section is the detail instruction of configuring behavior analysis rules.
Before You Start
Go to Configuration → System → Maintenance → VCA Resource Type , select Temperature
Measurement+Behavior Analysis.
Steps
1. Go to Configuration → VCA → Scene Parameters to create and edit a new scene.
2. Refer to Set the Scene Tracking for setting the scene tracking.
3. Refer to Set Rules to set the scene rules.
4. Refer to Set the Scene Patrol for setting scene patrol.
5. Go to Configuration → VCA Info → Overlay & Capture , enableIntelligent Analysis.
6. Click Save.
19