Table of Contents
Advertisement
Handling
4.4
Maintenance / Cleaning
4.4.1
Maintenance schedule
Maintenance tasks
Visual inspection
Check the tightening torques
4.4.2
Maintenance tasks
4.4.2.1
Visual inspection
• Check the entire gear unit for external damage.
• The radial shaft-sealing rings are wear parts. Therefore, check the gear unit for leaks during each
visual inspection.
◦ For further general information on radial shaft-sealing rings please refer to the website of our
partner http://www.simrit.de.
◦ In the installation position, check that no foreign media (e.g. oil) accumulate on the drive shaft.
4.4.2.2
Check the tightening torques
• Check the tightening torque of the fastening screws on the gear housing.
◦ The specified tightening torques can be found in Section 7 "Mechanical installation".
• Check the tightening torque of the set screws on the motor mounting.
◦ The specified tightening torques can be found in Section 7 "Mechanical installation".
4.4.3
Commissioning after maintenance
• Clean the gear unit externally.
• Attach all safety devices.
• Perform a test run before releasing the gear unit again for operation.
12
During commis-
After 500 hours
sioning
of operation or
3 months
X
X
Version: 1.6
Every 3 months Annually
X
X
X
X
AG2210
Advertisement
Table of Contents
