System Parameter Menu - Novexx Solutions ALX 73 Series Operating Manual

P
RODUCT DESCRIPTION
Settings: ["Foot first", "Head first"]
X - Printadjust
The zero point of the mask is shifted in relation to the edge of the label on the X-axis,
i.e. perpendicular to the material.

format with the modified values.
Setting range: [-5.0...+5.0] mm; presetting: 0 mm
Y – Printadjust
The zero point of the mask is shifted in relation to the punch position on the Y-axis, i.e.
in the direction of feed.

format with the modified values.
Setting range: [-5.0...+5.0] mm; presetting: 0 mm

SYSTEM PARAMETER menu

Light sens. type
Sensor type
Select the sensor type or the type of mark for beginning of the label (reflex marking or
punch).
Settings: ["Reflex", "Punched"]
Ribbon autoecon.
Ribbon saving (ribbon autoeconomisation)
Ribbon saving can be used to interrupt ribbon feed through areas of the label that are
not printed. This saves ribbon, especially for long labels with very little printed surface.
Settings: ["Thermal/head lift" "Thermal printing", "Enabled", "Off"]
Operating manual ALX 73x | file version 01 | 03/2012
•
"Foot first": Alignment of the print image as shown in [33A].
•
"Head first": Alignment of the print image as shown in [33B]. Note the following:

Define the "true" label length (without label gaps) in parameter
PRINT PARAMETERS > Material
SYSTEM PARAMETER > Miss. label tol.

The distance between the material zero line and the first printable dot is 1 mm.
To maintain this distance in head first mode, calculate the material using the fol-
lowing formula:
b = b – 2mm
, where
Mat Tr
b : Material width
Mat
b : Carrier material width
Tr
If the setting is changed while a print job is stopped, the printer recalculates the
•
Maximum adjust (offset) away from the edge of the label: +5.0 mm
•
No offset: 0.0 mm
•
Maximum offset toward the edge of the label: -5.0 mm
If the setting is changed while a print job is stopped, the printer recalculates the
•
Maximum offset in feed direction: +5.0 mm
•
No offset: 0.0 mm
•
Maximum offset opposite to feed direction: -5.0 mm
•
Reflex: Reflex sensor (detects reflex markings)
•
Punched: Transmission sensor (detects reflex punches)
length. If the label gap is longer than 5 mm parameter
must also be set to a value greater than zero.
ALX
73x
GB
Printer parameter menu | 40