Receive The Data - Analog Devices EVAL-ADPD6000 User Manual

User Guide
VSM CLIENT
Figure 33. Reading Individual Register
Figure 34. Writing Individual Register
6. If a Fail to read register or Fail to write register pop-up
appears (see Figure 35), check whether the device is discon-
nected or broken.
Figure 35. Error Message when Configuring Individual Register

RECEIVE THE DATA

Take the following steps to receive data from the FIFO after running
the EVAL-ADPD6000Z:
1. After connecting the device and loading the configuration file,
click Plot View to view the Plot View interface and click the run
button (see Figure 36).
Figure 36. Plot View Interface
2. The waveform appears in the Plot View page (see
37). If the waveform is out of scale, select the Enable Y-axis
Adaptation check box to adapt the vertical scale of the plot to
the waveform scale.
analog.com
3. To adjust the dots number on the x-axis, select a value from the
X-axis dots number dropdown menu (see
4. To view the waveforms of different slots and channels, select
the check boxes under PPG Show lines (see
ure 39
5. Click Start Export to begin exporting the data received (see
Figure
Figure
locally (see
file. Before clicking Stop Export, clear the Enable Y-axis
Adaptation check box. If this check box is selected, the da-
ta may fail to save. If the export is successful, a Success
to export data pop-up appears (see
location of the .xlsx file as follows: C:\Analog Devices\VSM
Client\VSM_Client\Export. In the Export folder, the file name
notes the date, time, and corresponding function of the export
(see Figure
EVAL-ADPD6000
Figure 37. Waveform
Figure 38. Change X-Axis Dots Number
shows slotA-Channel1 and slotB-Channel1 selected.
Figure 39. Select Slot and Channel Waveforms
40), and click Stop Export to stop exporting the data
Figure 41). The exported data is saved in an .xlsx
43).
Figure 38).
Figure 39). Fig-
Figure 42) noting the
Rev. 0 | 11 of 20