Adjustments Of The Feather-Steel-Lamellas - probst HVZ-UNI-II Operating Instructions Manual

Adjustments
5.5

Adjustments of the feather-steel-lamellas

●
The feather-steel-lamellas should not stitch out sideways over the contour of the laying cluster, because they could hit
the already laid blocks when laying a new cluster into an edge.
Depending on the length of a pack, the lamellas which are stitching over, should be replaced by the 1.5 lamella or the
half lamella.
●
It can be advantageous or even necessary to use special feather-steel-lamellas for certain stone layer systems (e.g.
hexagonal stones). Contact if necessary the manufacturer of the hydraulic installation machine (HVZ).
Bild 4
Tighten the self-locking nuts tight and then loosen them again by 1/2 turn. In order to give the feather-steel-lamellas a
higher flexibility and therefore a good, secure and gentle grip to the pavers.
When mounting the screws with the feather-steel-lamellas,
pay attention to the configuration of the three spring
washers as shown on the drawing (Fig. 11).
Steel-lamella
Fig. 5
Steel-lamella
23 / 41