Power On, Power Off, Reboot; Maintenance - Newland NLS-HR15-BT User Manual

Power On, Power Off, Reboot

Power on the scanner
Hold down the trigger on the scanner until it beeps.
Note: When using the scanner for the first time or after scanning the Battery Off barcode in Chapter 3, you MUST insert
the scanner in a powered cradle to exit battery protection mode before turning it on.
Power off the scanner
Method 1: When in the Level scan mode, the scanner will automatically power off after 5 minutes of inactivity.
Method 2: Scan the Power Off Scanner barcode in Chapter 3.
Reboot the scanner
If the scanner stops responding to input or runs abnormally, use a straightened paperclip to press and hold the Reset
button on the bottom of the scanner to reboot it.

Maintenance


The scan window should be kept clean.

Do not scratch the scan window.

Use soft brush to remove the stain from the scan window.

Use the soft cloth to clean the window, such as eyeglass cleaning cloth.

Do not spray any liquid on the scan window.

Do not use any detergent to clean other parts of the device except for water.
The warranty DOES NOT cover damages caused by inappropriate care and maintenance.
14