TDK-Lambda GH10-100 User Manual page 85

• Controller Access
The "One Client Only" setting is the default setting for the highest networking security. This
setting allows only one TCP socket to be open at a time, it disables the connectionless UDP
sockets. The multiple client setting is needed to allow more than one controller connection at a
time and to enable UDP sockets connections.
• Multicast DNS
mDNS is a protocol which allows devices on a network to advertise and use hostname
addressing even if no DNS server is connected. This service may be disabled for security
reasons or just to reduce network traffic.
Modify
•
Click this button to open the window shown in the next section.
B. LAN ➔ Configure ➔ Modify Page
The Modify button on the LAN  Configure page allows changing the LAN settings. The available
fields depend on the selection of DHCP Enabled / AUTO IP or Static IP. Changes to these setting
will take place only after clicking the Apply button.
The settings can be changed only by logging-in as 'admin'.
After changing the LAN settings, you are requested to close the web browser.
page. If the change duplicates IP, the
blink, IP address will revert to the previous state. Press any Front Panel button or encoder to stop
the blinking.
You may be required to perform AC reset of the power supply after changing the LAN settings.
TCP/IP Mode
This selects how the power supply receives network settings. Select one of the following:
• DHCP Enabled / AUTO IP: This is the default mode. If this mode is selected, the network
server uses DHCP to assign the IP address, subnet mask, default gateway and DNS server.
Figure 4–16: LAN – Changing Settings
NOTE
LAN Status green LED and the Front Panel display will
NOTE
74
Re-open the web