Table of Contents
Advertisement
4.14.8
Source Subsystem
[SOURce]:CURRent:EXTernal:LIMit[:STATe] <Bool>
Function
Parameter
Query
Return
[SOURce]:CURRent:EXTernal:MODE <DSC>
Function
Parameter
Query
Return
[SOURce]:CURRent[:LEVel][:IMMediate][:AMPLitude] <NRf+>
Function
Parameter
Unit
Query
Return
Example
[SOURce]:CURRent:SLEW:DOWN <NRf+>
Function
Parameters
Unit
Query
Return
Example
Enables/disables the current limit in the analog source control mode.
If enabled, the analog current programming range by the rear panel is
limited to a digital current programming value.
Refer to section 5.7 for additional information explaining OCL – Analog
Programming Over Current Limit.
0|1, OFF|ON
[SOURce]:CURRent:EXTernal:LIMit[:STATe]?
<Bool> 0|1
Sets the current programming source: Front panel/Communication (Digital),
external voltage, or external resistor.
0|1|2 or DIG|VOL|RES
[SOURce]:CURRent:EXTernal:MODE?
<DSC> DIG|VOL|RES
Sets a digital programming output current value.
The range is limited by the power supply model
A
[SOURce]:CURRent[:LEVel][:IMMediate][:AMPLitude]?
<NR2> 5-digits format
:CURR? returns the present programmed current level.
:CURR? MAX and :CURR? MIN return the maximum and minimum
programmable current level.
Sets a digital current reference down programming slew rate.
0.0001 ~ 999.99
A/mS
[SOURce]:CURRent:SLEW:DOWN?
<NR2>
:CURR:SLEW:DOWN 1 Sets digital current reference down programming
slew to 1A/mSec.
:CURR:SLEW:DOWN? returns a digital current down programming slope
value.
:CURR:SLEW:DOWN? MAX and :CURR:SLEW:DOWN? MIN return the
maximum and minimum digital current reference down programming slope
value.
112
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the GH10-100 and is the answer not in the manual?