TDK-Lambda GH10-100 User Manual page 160

Function
Constant Power Function
Constant Power Set Point [W]
Slew Mode
Voltage Slew Up / Down [V/mS]
Current Slew Up / Down [A/mS]
Internal Resistance Function
Internal Resistance Set Point [Ω]
Voltage Reference Programming Source
Current Reference Programming Source
Analog Mode Current Limit (OCL)
Analog Programming & Monitoring Range [V]
Programmable Pin 1
Programmable Pin 2
Front Panel Remote Mode
Front Panel LOCK
Output Sense (LOC / REM)
Interlock (ILC) Function
Enable (ENA) Function
Enable (ENA) Polarity
Power Supply OK (PS_OK) Delay [S]
Preload
Communication Interface
Communication Power Supply Address
Communication Baud Rate [Baud]
Communication Language
LAN parameters
Special Voltage Upper Limit (SVUL)
Special Current Upper Limit (SCUL)
Enable registers
Event registers
Power-On Status Clear
Display Brightness
Display Dim Delay [S]
Display Dim Brightness
Factory Calibration Parameters
Table 5-3: Single or Master Roles Non-Volatile Memory Parameters
LAN non-volatile memory parameters are not affected (for default parameters, refer to Table 2-7:
LAN Non-Volatile Memory Parameters). The only affected parameter is the Host Name which is
updated to default due to system identification update.
Single or Master Role
OFF
RATED VOLTAGE MULTIPLYED BY RATED CURRENT
OFF
999.99
999.99
OFF
0.001
DIG
DIG
OFF
5
OFF
OFF
LOCAL
OFF
LOC
OFF
OFF
REV
00.01
ON
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting), except Host Name
RATED
RATED
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
NOTE
149