Programming The Universal Mode 3 / 6 (Monophonic/Single Track) - Kelfar Technologies AK-5 PRO SE Manual Manual

E. Programming the Universal Mode 3 / 6 (Monophonic/Single Track)
1.
PRESS and HOLD the
Then, while holding down the
2.
LED Display shows
3.
Press the key "A#".
4.
LED Display shows
5.
Select Mode 3 using the "D" key or Mode 6 using the "F" key
6.
Expression and Breath Controller statues.
The LED Display shows EP or OFF or BC
Use the Transpose buttons to Turn ON/OFF:
EP
Expression Pedal is ON - TR (-)
OFF Expression Pedal and Breath Controller are OFF for (MIDI1) - RESET
BC
Breath Controller is ON for Primary (MIDI1) - TR (+)
7.
Press
CANCEL/POWER
LED Display shows
8.
Select the Incoming / Outputting Midi Channel and set to channel
TRANSPOSE/ADJUST (+) and (-)
9.
Press to confirm the Primary Channel Input
Tune/Setup
The LED Display shows CCn (Momentarily)
The LED Display shows Cxx (xx=00 to 119) or UL (Master Volume) i.e C11
Select the Control Change Number by using the Transpose/Adjust buttons.
10.
Press CANCEL to setup the Curvature by using the Transpose/Adjust buttons.
The LED Display shows Cux (x=0 to 8)
11.
Select the Curve by using the Transpose/Adjust buttons.
12.
Press
CANCEL/POWER
MIDI1)
13.
LED Display shows
14.
Press appropriate key to select the Brand of the instrument.
15.
Press CANCEL to skip programming the Secondary Instrument.
16.
Setup the USB MIDI PORTS 1&2
The LED Display shows i.e P01
17.
18.
Enable/Disable the USB PORTS by using the Transpose/Adjust buttons.
A. (+) Enable/Disable Port 1: 0 is OFF, 1 is ON
Copyright © 2005-20 Kelfar Technologies
AK-5 Pro SE/VERSION 4
www.kelfar.net
.
CANCEL/POWER
CANCEL/POWER
P1
P2
to set up the Incoming / Output Channel
Pc1
for Mode 3 and Mode 6
buttons.
to Exit programming the Universal Mode (Primary Instrument
S1
button, PRESS the
TUNE/SETUP
1
button.
by using the
22