Programming The Universal Mode 3 / 6 (Monophonic/Single Track) - Kelfar Technologies AK4 Pro SE Manual Manual

F. Programming the Universal Mode 3 / 6 (Monophonic/Single Track)
1. PRESS and HOLD the
Then, while holding down the
2.
LED Display shows
3. Press the key "A#".
4.
LED Display shows
5.
Select Mode 3 using the "D" key or Mode 6 using the "F" key
6.
LED Display shows
7. Select the Incoming / Outputting Midi Channel and set to channel
the
TRANSPOSE/ADJUST (+) and (-)
8.
Press
TUNE/SETUP
9.
LED Display shows the USB MIDI STATUS
STEP 10
A. (+) Enable/Disable Port 1: 0 is OFF, 1 is ON
B. (RESET) Enable/Disable Port 2: 0 is OFF, 1 is ON
It is best to disable the USB PORTS by using the Transpose/Adjust buttons + and Reset
10. Press the
CANCEL/POWER
The LED Display shows EP or OFF or BC
11.
Use the Transpose buttons to Turn ON/OFF:
EP
Expression Pedal is ON - TR (-)
OFF Expression Pedal and Breath Controller are OFF for (MIDI1) - RESET
BC
Breath Controller is ON for Primary (MIDI1) - TR (+)
12. Press
CANCEL/POWER
The LED Display shows CCn
13.
14.
Press
CANCEL/POWER
The LED Display shows Cxx (xx=00 to 119) or UL (Master Volume) i.e C11
15.
16.
Select the Control Change Number by using the Transpose/Adjust buttons.
17.
Press
CANCEL/POWER
The LED Display shows Cux (x=0 to 8)
18.
19.
Select the Curve by using the Transpose/Adjust buttons.
20.
Press
CANCEL/POWER
Notes:
1. For Universal Mode 3 /6 to work, connect the AK-4 Pro SE
multitimbral sequencer/Synthesizer/Keyboard Midi-In and Midi-Out. (see Figures 1 and
2 above .)
2. Your keyboard must support Pitch Bend Midi Data (for Mode 3) or Fine Tuning Midi
Data (for Mode 6).
AK-4 Pro SE/VERSION 3
www.kelfar.net
.
CANCEL/POWER
CANCEL/POWER
P1
P2
Pc
(Primary Channel) for Mode 3 or Mode 6
buttons.
to confirm
to confirm
to set up the Control Change
to setup the Control Change.
to setup the Curvature by using the Transpose/Adjust buttons.
to Exit programming the Universal Mode
Copyright © 2005-19 Kelfar Technologies
button, PRESS the
TUNE/SETUP
Pxx, P00
if it shows
MIDI IN/OUT
button.
1
by using the using
then skip to
to your
22