Table of Contents
Advertisement
14. Press
CANCEL/POWER
MIDI1)
15. LED Display shows
16. Press appropriate key to select the Brand of the instrument.
17. Press CANCEL to skip programming the Secondary Instrument.
18. Setup the USB MIDI PORTS 1&2
19. The LED Display shows i.e P01
20. Enable/Disable the USB PORTS by using the Transpose/Adjust buttons.
A. (+) Enable/Disable Port 1: 0 is OFF, 1 is ON
B. (RESET) Enable/Disable Port 2: 0 is OFF, 1 is ON
Options available:
A. P01 PORT 1 is ON. B. P11 PORTS 1&2 are ON. C. P10 PORT 2 is ON.
D. P00 PORTS 1&2 are OFF.
If USB PORTS 1&2 are OFF [P00], press CANCEL
21. The LED Display shows USB OFF momentarily and exit the USB MODE.
22. Press CANCEL to Exit programming the Secondary Instrument (MIDI2).
The LED Display shows FP (Fully PROGRAMMED)
Note: If either the Expression and Breath controller are ON then you will be able to select the
MIDI CHANNELS, CONTROL CHANGE, and CURVATURE. If the Expression or Breath
controller are OFF then the step will be skipped by pressing the CANCEL button to program the
Secondary Instrument (MIDI2).
After displaying FP the AK-5 Pro reboots indicating successful programming by displaying
the initial setting and Viewing Instrument Selections.
Notes:
1. For Universal Mode 1/2 to work, connect the AK-5 Pro SE
multitimbral sequencer/Synthesizer/Keyboard Midi-In and Midi-Out or USB MIDI Out.
(see figure 1 and 2 )
2. Your keyboard must support Fine Tuning Midi data (for Mode 1) or Pitch Bend Midi
Data (for Mode 2).
3. Set Keyboard to Local control off.(see Figure 1)
4. Set Pitch Bend Range to 2 for Mode 2.
5. You may further adjust the pitch of each note in the octave (C to B) to -64/+63 cents by
programming your own User Scales 01-09. User 00 is set to -50 cents "fixed."
AK-5 Pro SE/VERSION 4
www.kelfar.net
to Exit programming the Universal Mode (Primary Instrument
S1
Copyright © 2005-20 Kelfar Technologies
to your
MIDI IN/OUT
20
Advertisement
Table of Contents
