Table of Contents
Advertisement
6. Press CANCEL to setup the Curvature by using the Transpose/Adjust buttons.
The LED Display shows Cux (x=0 to 8)
7. Select the Curve by using the Transpose/Adjust buttons.
8. Press CANCEL to Exit programming the Primary Instrument (MIDI1).
Note: If either the Expression and Breath controller are ON then you will be able to select the
MIDI CHANNELS, CONTROL CHANGE, and CURVATURE. If the Expression or Breath
controller are OFF then the step will be skipped by pressing the CANCEL button to program the
Secondary Instrument (MIDI2).
Secondary Instrument
1. After programming the Primary Instrument:
LED Display shows
2. Press appropriate key to select the Brand of the instrument.
Press CANCEL to skip programming the Secondary Instrument.
The LED Display shows FP
The AK-5 Pro SE will reboot without programming the Secondary Instrument and the
(MIDI2) port will not output any data. In another word, the MIDI PORT for (MIDI2) has
been flittered OFF.
LED Display shows
3. Press appropriate key to select the specific Model of the instrument.
4. Expression and Breath Controller statues.
The LED Display shows EP or OFF or BC
Use the Transpose buttons to Turn ON/OFF:
EP
Expression Pedal is ON - TR (-)
OFF Expression Pedal and Breath Controller are OFF for (MIDI2) - RESET
BC
Breath Controller is ON for Secondary (MIDI2) - TR (+)
5. Press CANCEL to Select the MIDI CHANNELS by using the following buttons: (C to B)
1CH to 12CH, Tune/Setup 13CH, TR (-) 14CH, RESET 15CH, TR (+) 16CH.
The LED Display shows SCH
6. Press Cancel to setup the Control Change.
The LED Display shows CCn (Momentarily)
11
AK-5 Pro SE/VERSION 4
www.kelfar.net
S1
S2
Copyright © 2005-20 Kelfar Technologies
Advertisement
Table of Contents
