Programming Universal Modes 1/ 2 (Polyphonic / Two Tracks) - Kelfar Technologies AK-5 PRO SE Manual Manual

D. Programming Universal Modes 1/ 2 (Polyphonic / Two Tracks)
1. PRESS and HOLD the CANCEL/POWER.
Then, while holding down the CANCEL/POWER button, PRESS the TUNE/SETUP
button.
LED Display shows
2. Press the key "A#"
LED Display shows
3. Select Mode 1 "C" or Mode 2 "C#"
4. Expression and Breath Controller statues.
The LED Display shows EP or OFF or BC
Use the Transpose buttons to Turn ON/OFF:
EP
Expression Pedal is ON - TR (-)
OFF Expression Pedal and Breath Controller are OFF for (MIDI1) - RESET
BC
Breath Controller is ON for Primary (MIDI1) - TR (+)
5. Press
CANCEL/POWER
LED Display shows
6. Press
CANCEL/POWER
7. Select the Midi-In Channel (1-16)
8. Press
Tune/Setup
LED Display shows
9. Select the Midi-Out Channel (1-16)
10. Press
Tune/Setup
11. Press Cancel to setup the Control Change
The LED Display shows CCn (Momentarily)
The LED Display shows Cxx (xx=00 to 119) or UL (Master Volume) i.e C11
Select the Control Change Number by using the Transpose/Adjust buttons.
12. Press CANCEL to setup the Curvature by using the Transpose/Adjust buttons.
The LED Display shows Cux (x=0 to 8)
13. Select the Curve by using the Transpose/Adjust buttons.
19
AK-5 Pro SE/VERSION 4
www.kelfar.net
P1
P2
to set up the Incoming Channel
Pc1
for Mode 1 and Mode 2
to set up the Incoming Channel
1
to setup the Output Channel
PCO
for Mode 1 and Mode 2
2
Copyright © 2005-20 Kelfar Technologies
by using the
TRANSPOSE/ADJUST (+) and (-)
using the
TRANSPOSE/ADJUST (+) and (-)
buttons
buttons