Kelfar Technologies AK-5 PRO SE Manual Manual page 27

A. (+) Enable/Disable Port 1: 0 is OFF, 1 is ON
B. (RESET) Enable/Disable Port 2: 0 is OFF, 1 is ON
Options available:
A. P01 PORT 1 is ON. B. P11 PORTS 1&2 are ON. C. P10 PORT 2 is ON.
D. P00 PORTS 1&2 are OFF.
If USB PORTS 1&2 are OFF [P00], press CANCEL
The LED Display shows USB OFF momentarily and exit the USB MODE.
19.
20.
Press CANCEL to Exit programming the Secondary Instrument (MIDI2).
The LED Display shows FP (Fully PROGRAMMED)
Notes:
1. For Universal Mode 5/8 to work, connect the AK-5 Pro SE
multitimbral sequencer/Synthesizer/Keyboard Midi-In and Midi-Out. (see Figures 1 and
2 above )
2. Your keyboard must support Pitch Bend Midi Data (for Mode 5) or Fine Tuning Midi
Data (for Mode 8).
3. Set Keyboard to Local control off. (Figure 1)
4. Set Pitch Bend range to 2 for Mode 5.
5. You may further adjust the pitch of each note in the octave (C to B) to -64/+63 cents by
programming your own User Scales 01-09. User 00 is set to -50 cents "fixed."
27
AK-5 Pro SE/VERSION 4
www.kelfar.net
Copyright © 2005-20 Kelfar Technologies
to your
MIDI IN/OUT