Kelfar Technologies AK-5 PRO SE Manual Manual page 25

B. (RESET) Enable/Disable Port 2: 0 is OFF, 1 is ON
Options available:
A. P01 PORT 1 is ON. B. P11 PORTS 1&2 are ON. C. P10 PORT 2 is ON.
D. P00 PORTS 1&2 are OFF.
If USB PORTS 1&2 are OFF [P00], press CANCEL
The LED Display shows USB OFF momentarily and exit the USB MODE.
19.
20.
Press CANCEL to Exit programming the Secondary Instrument (MIDI2).
The LED Display shows FP (Fully PROGRAMMED)
Notes:
1. For this Universal Mode 4 to work, connect the AK5 Pro
sequencer/Synthesizer/Keyboard Midi-In and Midi-Out. (see Figures 1 and 2 above)
2. Set Keyboard to Channel 1
3. Your keyboard must support Pitch Bend Midi Data (for Mode 4) or Fine Tuning Midi
Data (for Mode 7).
4. Set Keyboard to Local control Off. (See Figure 1 above)
5. Set Pitch Bend range to 2 Mode 4.
6. You may further adjust the pitch of each note in the octave (C to B) to -64/+63 cents by
programming your own User Scales 01-09. User 00 is set to -50 cents "fixed."
25
AK-5 Pro SE/VERSION 4
www.kelfar.net
Copyright © 2005-20 Kelfar Technologies
to your multitimbral
MIDI IN/OUT