Programming Universal Modes 1/ 2 (Polyphonic / Two Tracks) - Kelfar Technologies AK4 Pro SE Manual Manual

E. Programming Universal Modes 1/ 2 (Polyphonic / Two Tracks)
1. PRESS and HOLD the CANCEL/POWER.
Then, while holding down the CANCEL/POWER button, PRESS the TUNE/SETUP
button.
LED Display shows
2. Press the key "A#"
LED Display shows
3. Select Mode 1 "C" or Mode 2 "C#"
LED Display shows
4. Select the Midi-In Channel (1-16)
5. Press
Tune/Setup
LED Display shows
6. Select the Midi-Out Channel (1-16) using the
7. Press
Tune/Setup
The LED Display shows P01 (USB PORT)
Enable/Disable the USB PORTS by using the Transpose/Adjust buttons.
A. (+) Enable/Disable Port 1: 0 is OFF, 1 is ON
B. (RESET) Enable/Disable Port 2: 0 is OFF, 1 is ON
Options available:
A. P01 PORT 1 is ON. B. P11 PORTS 1&2 are ON. C. P10 PORT 2 is ON.
D. . P00 PORTS 1&2 are OFF.
8. Press Cancel
9. Expression and Breath Controller statues.
The LED Display shows EP or OFF or BC
Use the Transpose buttons to Turn ON/OFF:
EP
Expression Pedal is ON - TR (-)
OFF Expression Pedal and Breath Controller are OFF - RESET
BC
Breath Controller is ON - TR (+)
10. Press Cancel to setup the Control Change.
The LED Display shows CCn
11. Press CANCEL to setup the Control Change.
The LED Display shows Cxx (xx=00 to 99) or UL (Master Volume) i.e C11
Select the Control Change Number by using the Transpose/Adjust buttons.
12. Press CANCEL to setup the Curvature by using the Transpose/Adjust buttons.
The LED Display shows Cux (x=0 to 8)
13. Select the Curve by using the Transpose/Adjust buttons.
14. Press CANCEL to Exit programming the Secondary Instrument (MIDI2).
The LED Display shows FP (Fully PROGRAMMED)
19
AK-4 Pro SE/VERSION 3
www.kelfar.net
P1
P2
Pc
for Mode 1 and Mode 2
1
by using the
SC
Copyright © 2005-19 Kelfar Technologies
TRANSPOSE/ADJUST (+) and (-)
TRANSPOSE/ADJUST (+) and (-)
buttons
2
buttons