Konica Minolta bizhub PRO C5501 User Manual page 289

Application functions
1
Position the original.
2
Touch [Application] on the Copy Screen.
3
Touch [Page Margin] on the Application Screen.
4
Touch [Reduce & Shift].
5
Select the side of copy paper to be adjusted with image position.
– Touch [Front] or [Back] to highlight it.
– Auto Zoom will automatically determine the reduction ratio according to the shift amount specified
for the front page. Setting for the back page is not required normally because the shift amount and
reduction ratio determined for the front page will be automatically applied to the back page.
6
Specify the shift direction and amount.
– Use [Top] or [Bottom] to shift the image in lengthwise direction, and [Right] or [left] in widthwise
direction. Touch the desired shift direction key to highlight it, then use [,] and [+], or touch panel
keypad to enter the desired shift amount.
– Setting the shift amount in 0.1 mm increments is also available in the Utility mode.
7
Repeat the steps 5 and 6, if setting the shift amount for front and back sides individually.
8
Touch [OK] to complete the setting.
– To restore the previous setting, touch [Cancel].
– To release the Page Margin function with the current setting remained, touch [Function Off].
9
Touch [OK] on the Application Screen.
The Copy Screen will be restored, with highlighted [Page Margin] key displayed under the [Application]
key.
Use this key to jump to the subsequent screen to make any setting change.
10
Enter the desired print quantity from the control panel keypad, then press [Start].
The machine will start printing when ready for output.
bizhub PRO C5501
11
11-47