Table of Contents
Advertisement
Adjusting the right/left audio balance
1)
Press as to select [AUDIO SETTING].
2)
Press the <ENTER> button.
f The [AUDIO SETTING] screen is displayed.
3)
Press as to select [BALANCE].
4)
Press qw to adjust the level.
Operation
Press w.
Press q.
Note
f The projector has no built-in speakers. Audio is output from the external audio device connected to the <AUDIO OUT> terminal.
[DC OUT]
This function can be used to supply power by the <DC OUT> terminal.
1)
Press as to select [DC OUT].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
[OFF]
Note
f An [ERROR] message is displayed and power supply is ceased when the power supplied by the connected device exceeds the rated power
(DC 5 V, maximum 2 A). When [ERROR] appears, please switch off and on the power of the projector.
f Power supply is ceased in standby mode even when [DC OUT] is set to [ON].
[STATUS]
Display the status of the projector.
1)
Press as to select [STATUS].
2)
Press the <ENTER> button.
f The [STATUS] screen is displayed.
3)
Press qw to switch the pages.
f The page will change each time you press the button.
[INPUT]
[SIGNAGE]
[SIGNAL NAME]
[SIGNAL FREQUENCY]
[PROJECTOR RUNTIME]
[LIGHT RUNTIME]
[INTAKE AIR TEMP.]
[OPTICS MODULE TEMP.]
[DC OUT]
[PROJECTOR TYPE]
[SERIAL NUMBER]
[MAIN VERSION]
[SUB VERSION]
[NETWORK VERSION]
Chapter 4 Settings — [SETUP] menu
Adjustment
Increases the volume on the right.
Increases the volume on the left.
Power is supplied to an external device connected to the <DC OUT> terminal.
Power is not supplied to an external device connected to the <DC OUT> terminal.
Displays the currently selected input.
Displays the status of signage playback.
Displays the input signal name.
Displays the frequency of the input signal.
Displays the runtime of the projector.
Displays the runtime of the light source.
Displays the status of the air intake temperature of the projector.
Displays the status of the internal temperature of the projector.
Displays the power supply status from the <DC OUT> terminal.
Displays the type of the projector.
Displays the serial number of the projector.
Displays the main version of the firmware of the projector.
Displays the sub version of the firmware of the projector.
Displays the network version of the projector.
Range of adjustment
L16 - R16
ENGLISH - 77
Advertisement
Table of Contents
