Panasonic PT-JX200GWU Operating Instructions Manual page 37

Chapter 2 Getting Started — Installing/removing the projector
13) Attach the safety wire.
i) Pull one end of the safety wire around the shaft holder and put through the loop as shown in the figure below.
ii) Secure the bracket of the safety wire with commercially available tapping screw (head diameter: Φ3.8 mm
(5/32")) to the sturdy ceiling with reinforcing material as shown in the figure below.
Ceiling foundation
(Field edge or
reinforcing material)
Ceiling material
(Gypsum board, etc.)
14) Align the orientation of the adapter to the track system.
f Hold up the adapter and align the orientation as follows.
g When using the track system of Nordic Aluminium, align the side with the protrusion (adapter) to the side
without the protrusion (track system).
g When using the track system of EUTRAC Stromschienen or ERCO, align the side with the protrusion
(adapter) to the side with the groove (track system).
Adapter
15) Mount the adapter to the track system.
f Insert the adapter into the opening of the track system.
f The adapter of the projector cannot be mounted to the position of the tapping screw fixing the track system
to the ceiling or beam.
Ceiling
Track system
For Nordic Aluminium
For EUTRAC Stromschienen
Track system
Protrusion
Within 600 mm
Pole
Cables from main unit
to power supply unit
(i)
Safety wire
Shaft holder
Track system Track system
Groove
Protrusion
Adapter
(ii)
Tapping screw
Bracket
Ceiling hole
Bracket
Tapping screw
For ERCO
Groove
ENGLISH - 37