Turning On/Off The Projector; Power Indicator - Panasonic PT-JX200GWU Operating Instructions Manual

Turning on/off the projector

Power indicator

Indicates the status of the power. Check the status of the power indicator <ON (G)/STANDBY (R)> before
operating the projector.
When the light source indicator <LIGHT> and the temperature indicator <TEMP> are lighting or blinking, a
problem may have occurred inside the projector. Check the status of the indicator before turning on the projector,
and take appropriate steps. (x page 134)
Indicator status
Off
Red
Green
*1 The indicator will blink in frequency of lighting 2.75 seconds → off 0.25 seconds → lighting 0.75 seconds → off 0.25 seconds.
*2 The indicator will blink in frequency of lighting 2.75 seconds → off 0.25 seconds.
Note
f The projector consumes power even in standby mode (when the power indicator <ON (G)/STANDBY (R)> is lighting or blinking in red).
Refer to "Power consumption" (x page 146) for the power consumption.
f The power indicator <ON (G)/STANDBY (R)> blinks in green if a remote control signal is received.
f The power indicator <ON (G)/STANDBY (R)> blinks in green in frequency of lighting 0.8 seconds → off 0.8 seconds while AV mute is in use.
f When the computer (including iPad/iPhone/iPod touch, Android devices) performs a connection check on the projector using the Panasonic
image transfer application software, the power indicator <ON (G)/STANDBY (R)> blinks in orange.
46 - ENGLISH
Chapter 3 Basic Operations — Turning on/off the projector
ON(G)/
STANDBY(R)
LIGHT
TEMP
SD
The power of the track system is turned off.
The power is switched off. (standby mode)
[STANDBY MODE] in the [SETUP] menu → [ECO MANAGEMENT] is set to [ECO].
Lighting Projection will start when the power <v/b> button is pressed.
f The projector may not operate when the temperature indicator <TEMP> is blinking.
(x page 134)
The power is switched off (in standby mode).
[STANDBY MODE] in the [SETUP] menu → [ECO MANAGEMENT] is set to
[NETWORK].
Blinking
*1
Projection will start when the power <v/b> button is pressed.
f The projector may not operate when the temperature indicator <TEMP> is blinking.
(x page 134)
The power is switched off (in standby mode).
[STANDBY MODE] in the [SETUP] menu → [ECO MANAGEMENT] is set to [NORMAL].
Blinking Projection will start when the power <v/b> button is pressed.
*2
f The projector may not operate when the temperature indicator <TEMP> is blinking.
(x page 134)
Lighting Projecting.
Power indicator <ON (G)/STANDBY (R)>
Light source indicator <LIGHT>
Temperature indicator <TEMP>
Projector status