Attaching The Caps To The Connecting Terminals - Panasonic PT-JX200GWU Operating Instructions Manual

Attaching the caps to the connecting terminals

It is recommended to attach the supplied terminal caps to the <HDMI IN> terminal and the <LAN> terminal
where cables are not attached, and the supplied card slot cap to the SD card slot to prevent dust getting into the
connecting terminals.
Before attaching the caps, check the shapes of the caps and the places to attach.
Note
f Attach the card slot cap with the opening of the "]" shaped rib facing the projector body. However, the card slot cap can also be attached
from the opposite side of the rib opening, but it may be difficult to take it out with the finger.
f The card slot cap can be attached even when an SD card is inserted.
The direction of attaching the card slot cap will differ as shown below depending on the presence of the SD card. Check the condition of the
SD card slot and the direction of the card slot cap before attaching.
f Do not insert with excessive force when attaching the cap. Doing so may damage the terminal or the cap.
Also, when attaching the card slot cap with the SD card inserted, the SD card will be in ejected state if it is pressed in too much.
44 - ENGLISH
Chapter 2 Getting Started — Connecting
LAN terminal cap
HDMI terminal cap
Card slot cap
SD card
Card slot cap
Gap of SD card slot
SD card