Table of Contents
Advertisement
Turning on the projector
1)
Turn on the power of the track system.
f The power indicator <ON (G)/STANDBY (R)> lights in red, and the projector enters the standby mode.
2)
Press the power <v/b> button.
f The power indicator <ON (G)/STANDBY (R)> lights in green and the projection is soon started.
Attention
f When turning on the projector, take notice of the people around the projector and ensure the light from the light source will not flash into
their eyes.
f The signage playback function of this projector can play still image/movie/audio files in the SD card or switch on/off the projector according
to the schedule registered beforehand.
When using the signage playback function to automatically turn on the projector at the start time set in the schedule, connect the power of
the track system at least three minutes before the start time.
Refer to "Operating Instructions – Content Manager Manual" for the signage playback.
Note
f The initial setting screen is displayed when the projector is turned on for the first time after purchase or when [ALL USER DATA] in the
[SETUP] menu → [INITIALIZE] is executed. Refer to "When the initial setting screen is displayed" (x page 47).
f If you press the power <v/b> button on the remote control to turn on the projector, the signal from the remote control can be reflected off
the projection surface to operate, but the operating range may be limited due to light reflection loss or the shape of the projection surface. In
such cases, operate with the remote control aimed toward the remote control signal receiver on the projector power supply unit.
f It may take longer for the projection to start when the [SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO] or
[NETWORK] when compared set to [NORMAL].
f When the power is turned on or an input signal is switched, you may hear a high-frequency driving sound. This is not a malfunction.
f When turning on the project in a low-temperature place, it may take some time before the projection starts and the color of the displayed
image becomes stable. This is not a malfunction.
f When the [SETUP] menu → [INITIAL STARTUP] is set to [LAST MEMORY], and the projection was ended by turning off the power of the
track system during projection last time, the power indicator <ON (G)/STANDBY (R)> will light in green and the projection will start a few
moments after the power supply of the track system is turned on.
When the initial setting screen is displayed
The initial setting screen is displayed when the projector is turned on for the first time after purchase or when [ALL
USER DATA] in the [SETUP] menu → [INITIALIZE] is executed. Set the following according to the circumstances.
In other occasions, you can change the settings by menu operations.
If you press the <RETURN> button while the initial setting screen is displayed, you can go back to the previous
screen.
Focus adjustment
Adjust the focus to display the menu screen clearly.
You may also need to adjust the zoom.
Refer to "Adjusting the projection" (x page 52) for details.
1)
Press asqw on the remote control to adjust the focus.
2)
Press the <MENU> button on the remote control to perform rest of the initial setting.
Chapter 3 Basic Operations — Turning on/off the projector
2)
LENS
FOCUS
ADJUST
2)
ENGLISH - 47
Advertisement
Table of Contents
