Table of Contents
Advertisement
Chapter 2 Getting Started — Installing/removing the projector
Note
f The setting of the phase selector switch can be changed even when the adapter is attached to the track system.
f When the phase selector switch is set to "0", the adapter and the track system are not electrically connected.
f If you do not know which number to set the phase selector switch, consult the installation personnel of your track system.
Mounting the projector to the track system
1)
Turn off the power of the track system.
WARNING
When mounting the projector to the track system, be sure to turn off the power of the track system.
Electric shocks can result.
2)
Turn the lever A to 90° against the longitudinal direction of the power supply unit.
f Turn the lever A on the track mount part A in the direction of the arrow shown in the figure so that the hook
clasp A is at 90° against the longitudinal direction of the power supply unit. Hook clasp A is parallel to the
longitudinal direction of the power supply unit.
Lever plate A
Lever A
3)
Completely turn the lever B to the same direction as the lever A against the power supply unit.
f Turn the lever B on the track mount part B in the direction of the arrow shown in the figure so that the hook
clasp B is parallel to the longitudinal direction of the power supply unit.
Track mount part A
Hook clasp A
Power supply unit
Track mount part B
Power supply unit
Hook clasp B
Lever B
ENGLISH - 33
Advertisement
Table of Contents
