20 Ball joint stopper
To free the ball joint movable part, remove the stopper.
(x page 38)
21 Connecting terminals cover (x page 24)
The connecting terminals are inside.
r Indicators
1
Power indicator <ON (G)/STANDBY (R)>
Indicates the status of the power. (x page 46)
2
Light source indicator <LIGHT>
Indicates the status of the light source. (x page 134)
r Connecting terminals and <DC OUT> terminal
1
<DC OUT> terminal
This is the USB terminal only used for power supply. (DC 5 V,
Maximum 2 A)
2
<LAN> terminal
This is the terminal to connect to the network. (x page 43)
Attention
f The LAN cable connecting to the projector directly should be wired indoors only.
f Store small parts such as SD card in an appropriate manner, and keep them away from small children.
24 - ENGLISH
Chapter 1 Preparation — About your projector
1
2
22 Pole
23 Shaft holder
24 Ball joint movable part
25 Shaft
26 Ball joint
1
ON(G)/
STANDBY(R)
2
LIGHT
3
TEMP
4
SD
3
Temperature indicator <TEMP>
Indicates the internal temperature status. (x page 134)
4
SD card indicator <SD>
Blinks in green when accessing the SD card.
3 4
3
<HDMI IN> terminal
This is the terminal to input HDMI signal. (x page 43)
4
SD card slot
Supports SD memory card and SDHC memory card.
(x page 53)