Table of Contents
Advertisement
WARNING:
r POWER
The circuit breaker shall be installed near the equipment and shall be easily accessible when problems
occur. If the following problems occur, cut off the power supply immediately.
Continued use of the projector in these conditions will result in fire, electric shock, or will cause visual
impairment.
f If foreign objects or water get inside the projector, cut off the power supply.
f If you notice smoke, strange smells or noise coming from the projector, cut off the power supply.
Please contact your dealer for repairs, and do not attempt to repair the projector yourself.
When mounting/removing the projector to/from the track system, or performing maintenance, be sure
to cut off the power supply.
Electric shocks can result.
When turning the adapter clockwise while holding the track system, make sure the electrical connection
is in good condition.
If the power connector is not inserted correctly, electric shocks or overheating will result.
f Do not use the power connector which is damaged.
Do not do anything that might damage the adapter.
f If the adapter is used while damaged, electric shocks, short-circuits or fire will result.
f Do not damage the power cord, make any modifications to it, place it near any hot objects, bend it
excessively, twist it, pull it, place heavy objects on top of it.
Ask an Authorized Service Centre to carry out any repairs to the adapter that might be necessary.
Do not use anything other than the provided adapter.
Failure to observe this will result in electric shocks or fire.
Do not handle the track system and the adapter with wet hands.
Failure to observe this will result in electric shocks.
During a thunderstorm, do not touch the projector or the track system.
Electric shocks can result.
Do not overload the track system.
If the power supply is overloaded (ex., by mounting too many devices), overheating may occur and fire will
result.
r ON USE/INSTALLATION
Ensure that track system is installed per manufacturer's instructions.
Inadequate installation may result in fire, electric shocks, or falling of the projector.
Mount the projector only to specified track systems.
Failure to observe this will result in fire, electric shocks, or falling of the projector.
Mount the projector to the track system which is installed in the horizontal ceiling or beam, and can
withstand the load.
Mounting the projector to the following track system will result in fire, electric shocks, or falling of the projector.
f Track system that is installed in the wall surface
f Track system that is installed in the sloping ceiling or beam
f Track system that cannot withstand the load
f Track system that is installed on the floor
Make sure that your footing is safe and secure during installation.
If your footing is not secure, you may tip over or fall down, and an injury may result.
Make sure that the mounting work is carried out by two or more persons.
Failure to observe this may result in damage or deformation of the projector, serious accidents or injury caused
by falling.
When mounting the projector to the track system, completely turn the lever of the track mount part to
the mounting direction.
Inadequate mounting to the track system will result in falling accident.
6 - ENGLISH
Read this first!
Advertisement
Table of Contents
