Table of Contents
Advertisement
Chapter 2 Getting Started — Installing/removing the projector
4)
Remove the safety wire.
Ceiling foundation
(Field edge or
reinforcing material)
Ceiling material
(Gypsum board, etc.)
5)
Loosen the lever locking screw.
f Turn each lever locking screw (M3) for the levers A/B counterclockwise until they turn freely, using a Phillips
screwdriver (ISO No. 2, diameter: 6 mm (1/4")), and release the levers A/B.
Lever B
Lever B locking screw
6)
Support the power supply unit with one hand, turn the lever B 90°, turn the lever A to the same side to
direct them 90° against the track system, and then remove the projector from the track system.
Ceiling
Track system
Lever plate A
Lever A
Lever plate B
Tapping screw
Pole
Cables from main unit
to power supply unit
(ii)
Safety wire
Shaft holder
Cross section
Lever A locking screw
Cross section
(i)
Bracket
Ceiling hole
Bracket
Tapping screw
Lever plate B
Lever B
Lever B locking screw
ENGLISH - 41
Advertisement
Table of Contents
