[Dc Out]; [Initialize All] - Panasonic PT-VW540 Operating Instructions Manual
Commercial use
Hide thumbs
Also See for PT-VW540:
- Operating instructions (functional manual) (131 pages) ,
- Operating instructions manual (134 pages)
Table of Contents
Advertisement
[DC OUT]
This function can be used to supply power by the <DC OUT> terminal.
1)
Press as to select [DC OUT].
2)
Press qw to switch the item.
f The items will switch each time you press the button.
[ON]
[OFF]
Note
f Power supply is ceased in standby mode even when [DC OUT] is set to [ON].
f If [DC OUT] is set to [ON] and a device which exceeds the rated power (DC 5 V, maximum 2 A) is connected to the projector, the projector
detects an error and ceases the power supply to the device. In such case, [ERROR] is displayed on the [DC OUT] screen. When [ERROR]
appears, remove the device and then switch off and on the power of the projector.
[INITIALIZE ALL]
Return various setting values to their factory default settings.
1)
Press as to select [INITIALIZE ALL].
2)
Press the <ENTER> button.
3)
When the [INITIALIZE ALL] screen is displayed, press qw to select [OK] and then press the <ENTER>
button.
4)
When the power off confirmation screen is displayed after a while, press the <ENTER> button.
f The operations except for powering off are disabled.
Note
f When the [SECURITY] menu → [PASSWORD] is set to [ON], the [PASSWORD] screen will be displayed after selecting [INITIALIZE ALL]
and pressing the <ENTER> button. Enter the security password set for the projector and continue your desired operation.
f The projector will enter the standby status to reflect the setting values when [INITIALIZE ALL] is executed.
f Even if [INITIALIZE ALL] is performed, the settings of the following items cannot be initialized.
g [STANDBY MODE]
g [EMULATE]
g [FILTER COUNTER]
g [NETWORK]
f To initialize the settings of [NETWORK], perform the [NETWORK] menu → [INITIALIZE].
f When [INITIALIZE ALL] is executed, the [INITIAL SETTING] screen is displayed when the projection starts next time.
Chapter 4 Settings - [PROJECTOR SETUP] menu
Power is supplied to an external device connected to the <DC OUT> terminal.
Power is not supplied to an external device connected to the <DC OUT> terminal.
ENGLISH - 85
Advertisement
Table of Contents
