Table of Contents
Advertisement
2)
Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3)
Press as to select [NO SIGNAL SHUT-OFF].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[10MIN.] - [90MIN.]
[DISABLE]
Note
f The factory default setting for [NO SIGNAL SHUT-OFF] is [10MIN.].
Setting [NO SIGNAL LIGHTS-OUT]
This is a function to automatically turn off the light source of the projector when the input is HDMI, MIRRORING,
or Panasonic APPLICATION and there is no input signal for a specific period. The time until the light source is
turned off can be set.
1)
Press as to select [ECO MANAGEMENT].
2)
Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3)
Press as to select [NO SIGNAL LIGHTS-OUT].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[DISABLE]
[10SEC.] - [5MIN.]
Note
f The power indicator <ON (G)/STANDBY (R)> will blink slowly in green while the no signal lights-out function is operating and the light source
is turned off.
f When [NO SIGNAL LIGHTS-OUT] is set to anything other than [DISABLE], after the light source is turned off by this function, the light
source will be turned on again in the following cases:
- When signal is input
- When on-screen display, such as menu screen (OSD) or input guide, or a test pattern is displayed
- When the power <v/b> button or the <AV MUTE> button is pressed
Setting [STANDBY MODE]
Set the power consumption during standby.
1)
Press as to select [ECO MANAGEMENT].
2)
Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3)
Press as to select [STANDBY MODE].
4)
Press qw to switch the item.
f The items will switch each time you press the button.
[ECO]
[NETWORK]
[NORMAL]
Note
f When [ECO] is set, network functions are not available during standby.
Chapter 4 Settings — [SETUP] menu
Sets the time in 10-minute intervals.
Disables [NO SIGNAL SHUT-OFF].
Disables [NO SIGNAL LIGHTS-OUT].
Turns off the light source when there is no input signal for the preset period.
Select [10SEC.], [20SEC.], [30SEC.], [1MIN.], [2MIN.], [3MIN.] or [5MIN.].
Select this item to reduce power consumption during standby.
Select this item to reduce power consumption during standby, and to operate the projector via wired
LAN using the Wake on LAN function.
Select this item to use the network function during standby.
Or, select this item to synchronize with the NTP server and adjust the date and time of the projector
automatically.
ENGLISH - 75
Advertisement
Table of Contents
