Before The Installation; Installation Form; Projection Direction - Panasonic PT-JX200GWU Operating Instructions Manual

Before the installation

This section describes the display method using the projector before mounting to the track system.

Installation form

There are a total of four installation forms: two for the projection method and two for the display direction. Set the
[SETUP] menu → [PROJECTION METHOD] (x page 70) and [VERTICAL FLIP] (x page 70) depending on
the installation form.
The following illustration is an example when the orientation of the main unit is adjusted to the location in the
figure above.
To project forward
A B C
Menu item
[PROJECTION METHOD]
[VERTICAL FLIP]
To project forward
Menu item
[PROJECTION METHOD]
[VERTICAL FLIP]
Note
f Above illustrations for installation form are examples for explanation, and it may not be the actual condition of usage. Set the [SETUP] menu
→ [PROJECTION METHOD] (x page 70) and the [VERTICAL FLIP] (x page 70) according to the environment of the usage and the
direction of the main unit.

Projection direction

Various expressions are possible by combination of adjustment of the direction of the main unit as described
in "Adjusting the projection position" (x page 38) and the settings of the [SETUP] menu → [PROJECTION
METHOD] (x page 70) and the [VERTICAL FLIP] (x page 70).
The following illustration is an example when [PROJECTION METHOD] is set to [FRONT] and [VERTICAL FLIP]
is set to [OFF].
28 - ENGLISH
Chapter 2 Getting Started — Before the installation
Method
[FRONT]
[OFF]
Method
[FRONT]
[ON]
A B C
To project from rear
(Using the translucent screen)
Menu item
[PROJECTION METHOD]
[VERTICAL FLIP]
To project from rear
(Using the translucent screen)
Menu item
[PROJECTION METHOD]
[VERTICAL FLIP]
A B C
Method
[REAR]
[OFF]
Method
[REAR]
[ON]