Connecting Terminals - Panasonic PT-VZ570 Service Manual

SECTION 1 SERVICE INFORMATION

1. 3. Connecting terminals

r Connecting terminals
1 <COMPUTER 2 IN/1 OUT> terminal
This is the terminal to input RGB signals or YC
signals.
Or output the RGB signals or YC
external device.
2 <COMPUTER 1 IN> terminal
This is the terminal to input RGB signals, Y/C signals or
YC C /YP
P signals.
B R B R
3 <HDMI 1 IN> terminal
This is the terminal to input HDMI1 signals.
4 <HDMI 2 IN> terminal
This is the terminal to input HDMI2 signals.
5 <LAN> terminal
This is the LAN terminal to connect to the network.
6 <SERIAL IN> terminal
This is the RS-232C compatible terminal to externally
control the projector by connecting a computer.
Attention
f When a LAN cable is directly connected to the projector, the network connection must be made indoors.
Chapter 1 Preparation - About your projector
C /YP
P
B R B R
C /YP
P signals to an
B R B R
INF-4
Some of the pages on this section are excerpted from the owner's
manual, thus the reference page numbers on pages indicate those
for owner's manual .
7 <VIDEO IN> terminal
This is the terminal to input video signals.
8 <AUDIO IN 3 (L/R)> terminal
This is the terminal to input audio signals.
Left input <L> and right input <R> are provided for the
<AUDIO IN 3> terminal.
9 <AUDIO IN 1> terminal
This is the terminal to input audio signals.
10 <AUDIO IN 2 (MIC IN)> terminal
This is the terminal to input audio signals. Or connect the
MIC to this terminal.
11 <VARIABLE AUDIO OUT> terminal
This is the terminal to output the input audio signal to the
projector.