Before The Installation; Projection Mode; Installation Form - Panasonic PT-JW130GBD Operating Instructions Manual

Before the installation

This section describes the display method using the projector before mounting to the track system.

Projection mode

The projection mode of the projector can be switched to the lighting mode to use the projector as a spot light, or to the projector mode to
project an image by pressing the <LIGHTING/PROJECTOR> button on the remote control. (x page 49)

Installation form

There are total of 4 installation forms, 2 for the projection method and 2 for the display direction, when using the projector in the projector
mode. Set the [SETUP] menu → [PROJECTION METHOD] (x page 68) and [VERTICAL FLIP] (x page 69) depending on the installation
form.
To project forward
A B C
Menu item
[PROJECTION METHOD]
[VERTICAL FLIP]
To project forward
Menu item
[PROJECTION METHOD]
[VERTICAL FLIP]
Note
f Above illustrations for installation form are examples for explanation, and it may not be the actual condition of usage. Set the [SETUP] menu
→ [PROJECTION METHOD] (x page 68) and the [VERTICAL FLIP] (x page 69) according to the environment of the usage and the
direction of the main unit.
26 - ENGLISH
Chapter 2 Getting Started — Before the installation
Lighting mode (example)
Method
[FRONT]
[OFF]
Method
[FRONT]
[ON]
A B C
Projector mode (example)
To project from rear
(Using the translucent screen)
Menu item
[PROJECTION METHOD]
[VERTICAL FLIP]
To project from rear
(Using the translucent screen)
Menu item
[PROJECTION METHOD]
[VERTICAL FLIP]
A B C
Method
[REAR]
[OFF]
Method
[REAR]
[ON]