Table of Contents
Advertisement
4-24
Reports
Configuration for route report
Specific data
Printing out the report for route/machine template
You can print out the following measurements as reports to
document the results in a route/machine template:
All overall values, Trend parameters from TrendingSpectrum,
Visual inspection, All phase measurements
In addition to a table of results, the report contains general
information and additional data on the measurement. Threshold
values are automatically added if they are exceeded during
measurement.
• Open the route/template.
• In the tree view, mark the entry for which you wish to create the
report.
The results of all measurement locations located below this entry
in the hierarchy are printed out.
• Press the MENU key and click on 'Print'. The report configuration
appears.
• If necessary, change the report configuration.
The settings in the 'Common settings' tab are the same as the
settings for the measurement reports (see previous page). The
following detailed data can be set in the 'Measure info' tab.
Unmeasured jobs: Measurement tasks that have not been measured
are included in the report.
RPM: The speed is printed out if available.
Caption: A legend is output as an appendix to the report.
Overall value: Selection of the vibration values
Table orientation: Arrangement of the measurement tasks in the
table (horizontal/vertical).
Paper orientation: Paper orientation selectable between portrait or
landscape.
Start the printout as described under 'Printing out the measurement
report' (see previous page).
Advertisement
Table of Contents
