Table of Contents
Advertisement
• In the next screen, set up the COM port to be used on the PC.
• Enter the IP address that is to be used by VIBXPERT.
'Local IP address' appears only if the PC has access to more than
one network (virtual or physical). In this case, specify the IP
address of the PC to be used for communication with VIBXPERT.
• Click on OK.
• Switch VIBXPERT off and on again.
The update tool subsequently contacts VIBXPERT and starts
transfer of the basic firmware. The progress of the data transfer
is shown in the right pane: 'Transferring data X%'
• Then it is only necessary to load the firmware: To do this, follow
the instructions on Page 2-37.
Appendix - Troubleshooting
6-19
Advertisement
Table of Contents
