Table of Contents
Advertisement
Default sensor is active, when
•
Channel A / Channel B is marked red in the task selection
screen
•
the sensor icon at the top edge of the task selection screen is
orange
•
the sensor setup cannot be opened in the measurement task
manager.
Use the default sensor for measuring or deactivate this option. Oth-
erwise, incorrect measurements may be the result.
Keyphaser
Here you can extend the time limit set for rpm measurements
and phase measurement to enable measurements on very low-
speed machines (range: 10 ... 30 s, default: 10 s). In coast-down
measurements the time limit is automatically set in relation to the
stop speed.
The 'Active edge' option is used to define whether the edge of the
incoming trigger mark or outgoing trigger mark on the shaft is to be
used as the reference signal.
Language
VIBXPERT includes 11 languages. The default setting is 'English'. To
change the language setting, proceed as follows:
• Click on 'Language'.
• Click on 'YourLanguage' (e.g. Espanol, Francais,...).
• Press MENU and click on 'OK'.
• Confirm the resulting message to restart the application (see
below).
Getting started - Basic settings
Note
Left:
Dialog language
is changed to 'Deutsch' (German)
Right:
Default vibration sensor is enabled
2-23
Advertisement
Table of Contents
