Emerson Rosemount 2160 Reference Manual page 30

Installation
May 2022
3.3.8 Adjust LCD meter orientation
If a device display is ordered, it will be shipped attached to the level detector. The display is
ordered in the level detector model number, option code M5.
Rotate the device display
The device display can be rotated in 90-degree increments.
Procedure
1. Squeeze the two black tabs on opposite sides of the display. Refer to
2. Gently pull out the display.
3. Rotate the display to the desired orientation, and snap the display into place.
3.3.9 Adjust housing orientation
The housing can be rotated for optimal viewing of the optional LCD display and to get the
best antenna position.
Procedure
1. Loosen the set screw until the level detector housing can rotate smoothly.
2. First, rotate the housing clockwise to the desired location.
30
Figure 3-16: Device Display
A. Display pins
B. Black tabs
C. Display
D. Cover
Note
If the device display four-pin connector is inadvertently removed from the interface
board, carefully reinsert the connector before snapping the device display back into
place.
Do not unscrew all the way. Rotating the housing, without this screw in place, can
damage the internal wiring.
If the desired location cannot be achieved due to thread limit, rotate the housing
counterclockwise.
A B
Reference Manual
00809-0100-4160
Figure 3-16.
C D
Reference Manual