Slope Trigger - Rigol DS1302CA User Manual

RIGOL

Slope Trigger

Slope trigger sets the oscilloscope as the positive/negative slope trigger within the
specified time.
Press MENU→Mode→Slope to enter the following menu.
Figure 2-43 Table 2-23 The Slope Trigger menu (Page 1/2)
Figure 2-44 Table 2-24 The Slope Trigger menu (Page2/2)
2-34
Menu
Settings
CH1
CH2
Source
EXT
EXT/5
When
Time
<Time Set>
Menu
Settings
Vertical
Auto
Normal
Sweep
Single
Set Up
Comments
Set channel 1 as trigger source.
Set channel 2 as trigger source.
Set EXT. channel as trigger source.
Set EXT/5 as trigger source.
Set slope condition as "+slope more than"
Set slope condition as "+slope less than"
Set slope condition as "+slope equal to"
Set slope condition as "-slope more than"
Set slope condition as "-slope less than"
Set slope condition as "-slope equal to"
Set slope time.
Comments
Select the level that can be adjusted by
.
Force the oscilloscope to trigger in the
absence of trigger condition.
Lets oscilloscope to trigger in the suitable
trigger condition.
Lets oscilloscope to trigger one time in the
suitable trigger condition, then stop.
To go to set up menu. See Table 2-32.
User‟s Guide for DS1000CA Series