Rigol DS1302CA User Manual page 28

RIGOL
· Press NO.1 menu button to choose Edge.
· Press NO.2 menu button to choose Source as CH1.
· Press NO.3 menu button to choose Slope as
· Press NO.4 menu button to choose Sweep as Auto.
· Press NO.5 menu button to enter secondary menu of Set Up.
Figure 1-11
NOTE: The trigger mode, slope and source change in conjunction with the status bar
on the top-right of the screen.
3. Press 50%
The 50% button sets the trigger level to the center of the signal.
4. Press FORCE
Starts an acquisition regardless of an adequate trigger signal, usually used in
"Normal" or "Single" trigger mode. This button has no effect if the acquisition is
already stopped.
Local/Remote control
When the instrument is in remote mode, press FORCE to switch to local
mode.
1-16
.
User‟s Guide for DS1000CA Series