Track Mode - Rigol DS1302CA User Manual

RIGOL

Track Mode

Press Cursor→Mode→Track to display the track mode menu.
Figure 2-116 Table 2-77 Track mode menu
In Track mode, the cross cursor is displayed on the waveform under measuring. If
you move the horizontal position of cursor, the horizontal coordinate and vertical
coordinate of current point as well as the increments of them will be displayed
immediately. Note: horizontal coordinate represents time value, vertical coordinate
represents voltage value.
To do Track mode Cursor Measurements, follow these steps:
1. Select the Track mode for cursor measurement by pressing soft button as:
Cursor→Mode→Track.
2. Select channel Source for Cursor A and Cursor B by pressing soft button as:
Cursor→Cursor A or Cursor B→CH1, CH2 or None.
3. Move the cursors to adjust the horizontal positions of the cursors:
2-84
Menu Settings
Mode Track
CH1
Cursor A CH2
None
CH1
Cursor B CH2
None
CurA
(Cursor A)
CurB
(Cursor B)
Comments
Set Track mode in cursor measurement.
Set Cursor A in conjunction with CH1,
CH2 or turn off Cursor A.
Set Cursor B in conjunction with CH1,
CH2 or turn off Cursor B.
Turn the multifunctional Knob (
move cursor A Horizontally.
Turn the multifunctional knob (
move cursor B horizontally.
User‟s Guide for DS1000CA Series
) to
) to