Removing The; Removing The Rear Cover - Supermicro SuperStorageSystem SSG-2028R-DN2R24L User Manual

Table of Contents

Advertisement

SUPERSTORAGESYSTEM SSG-2028R-DN2R24L User's Manual
6-4
Removing the Front Cover
Figure 6-2. Removing the Front Cover
1
2
1
3
Remove Screw
Removing the Front Cover
1. Power down the system and remove the power cords from the rear of the
power supplies as described in Section 6-3.
2. Remove the two screws securing each side of the top front cover .
3. Push in the release buttons on both sides of the chassis.
4. Lift the top front cover off the chassis.
Caution: Except for short periods of time, do not operate the server without the cover
in place. The chassis cover assists with proper airflow that prevents overheating.
1
2
Remove Screw
6-4
6-5

Removing the Rear Cover

Figure 6-3. Removing the Rear Cover
Removing the Rear Cover
1. Power down the system and remove the power cords from the rear of the
power supplies as described in Section 6-3.
2. Remove the front cover as described in Section 6-4.
3. Remove the fourteen screws securing the rear cover to the chassis and set
them aside for use when the cover is replaced..
4. Lift the rear cover off the chassis.
Caution: Except for short periods of time, do not operate the server without the cover
in place. The chassis cover assists with proper airflow that prevents overheating.
Chapter 6: Advanced Chassis Setup
Remove
1
1
3
2
Fourteen
Screws
6-5

Advertisement

Table of Contents
loading

Table of Contents