Table of Contents
Advertisement
SUPERSTORAGESYSTEM SSG-2028R-DN2R24L User's Manual
•
If the rack is provided with stabilizing devices, install the stabilizers before
mounting or servicing the unit in the rack.
2-5
Installing the System into a Rack
This section provides information on installing the SC227 chassis into a rack unit
with the quick-release rails provided. There are a variety of rack units on the market,
which may mean the assembly procedure will differ slightly. You should also refer to
the installation instructions that came with the rack unit you are using.
Note: This rail will fit a rack between 26.5" and 36.4" deep.
Identifying the Sections of the Rack Rails
The chassis package includes two rail assemblies in the rack mounting kit. Each
assembly consists of three sections: An inner rail that secures directly to the chassis,
an outer rail that secures to the rack, and a middle rail that slides in the outer rail.
These assemblies are specifically designed for the left and right side of the chassis.
Figure 2-1. Identifying the Inner Rails, Middle Rails and Outer Rails
Left Outer
Rail
Middle Rails,
Front
Inner Rails
Inner Rails
Outer Rails,
Rear
Right Outer
Rail
2-4
Releasing the Inner Rail
It is necessary to release the inner rail from the middle and outer rails before
installing the inner rail on the chassis.
Releasing the Inner Rail from the Middle and Outer Rails
1. Lift the front latch on the inner rail and pull the inner rail out of the middle rail,
and the middle rail out of the outer rail until the rails are fully extended.
2. Press down the locking lever on the inside of the inner rail to release the
inner rail. Continue to pull the inner rail out of the middle rail.
Figure 2-2. Extending the Rails and Releasing the Inner Rail
Front Latch on
Inner Rail
Inner Rail
Locking Lever
on Inner Rail
Front Latch
2-5
Chapter 2: Server Installation
Locking Lever on
Middle Rail
(on inside of rail)
Outer Rail
Middle Rail
Advertisement
Table of Contents
