Supermicro SuperStorageSystem SSG-2028R-DN2R24L User Manual page 32

SUPERSTORAGESYSTEM SSG-2028R-DN2R24L User's Manual
2. Press the second load lever labeled 'Close 1st' to release the load plate that
covers the CPU socket from its locking position.
Press down on Load the Lever
labeled 'Close 1st'
3. With the lever labeled 'Close 1st' fully retracted, gently push down on
the 'Open 1st' lever to open the load plate. Lift the load plate to open it
completely.
Gently push down to pop the
load plate open.
4. Using your thumb and the index finger, remove the 'WARNING' plastic cap
from the socket.
Pull lever away
from the socket
5-4
5. Use your thumb and index finger to hold the CPU on its edges. Align the CPU
keys, which are semi-circle cutouts, against the socket keys.
Socket Keys
6. Once they are aligned, carefully lower the CPU straight down into the socket.
(Do not drop the CPU on the socket. Do not move the CPU horizontally or
vertically. Do not rub the CPU against the surface or against any pins of the
socket to avoid damaging the CPU or the socket.)
Caution: You can only install the CPU inside the socket in one direction. Make sure
that it is properly inserted into the CPU socket before closing the load plate. If it doesn't
close properly, do not force it as it may damage your CPU. Instead, open the load
plate again and double-check that the CPU is aligned properly.
Chapter 5: Advanced Motherboard Setup
CPU Keys
5-5