Table of Contents
Advertisement
SUPERSTORAGESYSTEM SSG-2028R-DN2R24L User's Manual
Installing The Inner Rails on the Chassis
Installing the Inner Rails
1. Confirm that the left and right inner rails have been correctly identified.
2. Place the inner rail firmly against the side of the chassis, aligning the pins on
the side of the chassis with the slotted thru holes in the inner rail.
3. Slide the inner rail toward the rear of the chassis until the pins are at the end
of the narrow slot, which secures the inner rail to the chassis. An optional
screw may be added for extra security.
4. Repeat for the other inner rail.
Figure 2-3. Installing the Inner Rails
Warning: Do not pick up the server with the front handles. They are designed
to pull the system from a rack only.
2
3
2-6
Installing the Outer Rails on the Rack
Installing the Outer Rails
1. Confirm that the left and right outer rails have been correctly identified.
2. Release the small locking lever on the inside of the middle rail and push the
middle rail back into the outer rail.
3. Insert the square pins at the front of the outer rail into the square holes on
the front of the rack. Push until the latch snaps into place.
4. The outer rail is actually two pieces that slide to lengthen. Pull out the rear of
the outer rail, adjusting the length until the square pin assembly passes, then
fits against the back of the rear post. Be careful to keep the rail level.
5. Insert the square pins at the rear of the outer rail into the square holes on the
rear of the rack. Push until the latch snaps into place.
6. Repeat for the other outer rail.
Figure 2-4. Installing the Outer Rails
Stability Hazard: The rack stabilizing mechanism must be in place, or the
rack must be bolted to the floor before you slide the unit out for servicing. Failure to
stabilize the rack can cause the rack to tip over.
Chapter 2: Server Installation
Locking Lever on
Middle Rail
2-7
Advertisement
Table of Contents
