HAWKER HURRICANE
CONTROL THROWS
1) We highly recommend setting up a plane
using the control throws listed.
2) The control throws should be measured at
the widest point of each control surface.
3) Check to be sure the control surfaces move
in the correct directions.
Control throw Ailerons:
Low: 10mm up / down.
High: 15mm up / down.
Control throw Flaps:
Mid: 16mm down.
Control throw Elevators:
Low: 8mm up / down.
High: 12mm up / down.
Control throw Rudder:
Low: 20mm left / right.
High: 25mm left / right.
Aileron control
Flap control
Elevator control
Rudder control
16
Item code: BH147.
1) Completely charge your transmitter and
receiver batteries before your first day of flying.
2) Check every bolt and every glue joint in
your plane to ensure that everything is tight and
well bonded.
3) Double check the balance of the airplane.
4) Check the control surface.
5) Check the receiver antenna . It should be fully
extended and not coiled up inside the fuselage.
6) Properly balance the propeller.
We wish you many safe and enjoyable
flights with your
10mm
10mm
16mm
8mm
8mm
20mm
20mm
Instruction Manual
PRE-FLIGHT CHECK
HAWKER HURRICANE.