1.888.610.7664
12. Clock setting (KEW3552/ 3552BT only)
This instrument has an internal clock and can save the measured data with
time information. (Not available on KEW3551.)
12-1 Setting
(1) Get the instrument into setting mode.
1. S et the function switch to any position other than low-resistance
measurement, and then hold down the SETUP button ( 2 sec.) while
in the stand-by mode.
3. U se the cursor key and toggle the screens for clock setting; blinking
appears on the LCD.
Blink
(2) P ress the ENTER button and adjust time and date according to the
following sequences.
1. Use the cursor key to adjust
the last two digits of year,
and confirm with the ENTER
button.
Blink
2. Use the cursor key to adjust
the month and date, and
confirm with the ENTER
Blink
button.
3. Use the cursor key to adjust
the current time, and
confirm with the ENTER
Blink
button.
To go one step back, press the ESC button.
Setting completes when blinking
described above.
(3) P ressing the ESC button saves the changes you made and the instrument
returns to stand-by mode. The changes you made are saved and won t be
cleared even after powering off the instrument.
̶ 36 ̶
www.calcert.com
15
10
20
5
25
0
30
Fig. 12-1
Adjust
Fig. 12-2
Adjust
Fig. 12-3
Adjust
Fig. 12-4
appears after step 3.
sales@calcert.com