Prestige 650R-31/33 ADSL Router
4.2
Remote Node Setup
For the TCP/IP parameters, perform the following steps to edit Menu 11.3 – Remote Node Network
Layer Options as shown next.
Step 1.
In menu 11.1, make sure IP is among the protocols in the Route field.
Step 2.
Move the cursor to the Edit IP/Bridge field, press [SPACE BAR] to select Yes, then press
[ENTER] to display Menu 11.3 – Remote Node Network Layer Options.
IP Options:
IP Address Assignment = Dynamic
Rem IP Addr = 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= N/A
NAT= None
Metric= 2
Private= No
RIP Direction= None
Multicast= None
IP Policies=
The next table explains fields in Menu 11.3
FIELD
IP Address
Assignment
Rem IP Addr
Rem Subnet Mask
4-6
Menu 11.3 - Remote Node Network Layer Options
Address Mapping Set= N/A
Version= RIP-1
Enter here to CONFIRM or ESC to CANCEL:
Figure 4-3 Remote Node Network Layer Options
–
Table 4-2 Remote Node Network Layer Options
Press [SPACE BAR] and then [ENTER] to select Dynamic if the
remote node is using a dynamically assigned IP address or Static if
it is using a static (fixed) IP address. You will only be able to
configure this in the ISP node (also the one you configure in menu
4), all other nodes are set to Static.
This is the IP address you entered in the previous menu.
Type the subnet mask assigned to the remote node.
Bridge Options:
Ethernet Addr Timeout(min)= N/A
Remote Node Network Layer Options.
DESCRIPTION
EXAMPLE
Dynamic
Remote Node Configuration