Applying Filters And Factory Defaults; Figure 8-16 Sample Filter Rules Summary – Menu - ZyXEL Communications Prestige 650R-31/33 User Manual

Prestige 650R-31/33 ADSL Router
# A Type
- - ---- --------------------------------------------------------------- - - -
1 Y IP Pr=6, SA=0.0.0.0, DA=0.0.0.0, DP=23
2 N
3 N
4 N
5 N
6 N
This shows you that you have
configured and activated (A = Y) a
TCP/IP filter rule (Type = IP, Pr = 6)
for destination telnet ports (DP =
23).
After you have created the filter set, you must apply it.
Step 1. Enter 11 in the main menu to display menu 11 and type the remote node number to edit.
Step 2. Go to the Edit Filter Sets field, press [SPACE BAR] to choose Yes and press [ENTER].
Step 3.
This brings you to menu 11.5. Apply the example filter set (for example, filter set 3) in this
menu as shown in the next section.
8.6

Applying Filters and Factory Defaults

This section shows you where to apply the filter(s) after you design it (them). Sets of factory default filter
rules have been configured in menu 21 (but have not been applied) to filter traffic.
8-18
Menu 21.1 - Filter Rules Summary
Filter Rules
Enter Filter Rule Number (1-6) to Configure: 1
Figure 8-16 Sample Filter Rules Summary – Menu 21.1
M = N means an action can be taken immediately.
The action is to drop the packet (m = D) if the
action is matched and to forward the packet
immediately (n = F) if the action is not matched no
matter whether there are more rules to be
checked (there aren't in this example).
M m n
N D F
Filter Configuration