This chapter is about parameters that are protocol independent. The protocol-dependent
A remote node is required for placing calls to a remote gateway. A remote node represents both the remote
gateway and the network behind it across a WAN connection. Note that when you use menu 4 to set up
Internet access, you are actually configuring one of the remote nodes.
4.1
Remote Node Setup
This section describes the protocol-independent parameters for a remote node.
4.1.1 Remote Node Profile
To configure a remote node, follow these steps:
Step 1.
In the main menu, enter 11 to open menu 11 - Remote Node Setup.
Step 2.
When menu 11 appears, as shown below, enter the number of the remote node that you wish to
configure.
Remote Node Configuration
Remote Node Configuration
configuration will be covered in subsequent chapters.
Prestige P645 ADSL Internet Access Router
Chapter 4
4-1